How to Install Your RippleFold Drapes
RippleFold drapes are designed for easy DIY installation. Follow this guide to get a professional-looking result every time.
🔧 Gather Your Tools
You'll need: drill with appropriate bits, level, pencil, measuring tape, wall anchors or stud finder, and screwdriver. A helper for large panels is recommended.
📐 Mark Your Track Position
Using your measurements and a level, mark the wall or ceiling where the track brackets will be mounted. Ensure marks are perfectly level — this is critical for straight-hanging drapes.
🪛 Install the Track Brackets
Drill pilot holes, insert anchors (if not mounting into studs), and secure each bracket with screws. Verify level again after installing the first and last brackets.
🛤 Snap the Track into Brackets
Following your track manufacturer's instructions, snap or screw the RippleFold track into the mounted brackets. Verify the track is level and secure at all bracket points.
🪟 Insert Carriers and Hang Panels
Insert the ripplefold carriers into the track from one end. Attach each glider hook to the sewn-in tape at equal intervals along the top of your drape panel. Ensure the wave pattern is uniform before closing the end stop.
✅ Final Adjustment
Open and close the drape fully to check the wave is uniform and the panel glides smoothly. Adjust carrier spacing if needed. Check that the panel hangs level and reaches your desired endpoint.
Need professional installation?
Our team handles the entire installation for you. Available in Palm Beach, Broward & Miami-Dade counties.